A network bridge is a device that connects nodes on multiple network segments. In Ethernet bridging is sometimes called transparent bridging because bridges presence and operation are transparent to network hosts. A bridge works at the data link layer (Layer 2) of the OSI model.
To determine if it needs to send a data frame to a different segment, it reads the frame's destination MAC address. If it determines that the destination node is on another segment on the network, it forwards (retransmits) the frame to that segment. If the destination address belongs to the same segment as the source address, the bridge filters (discards) the frame.
A bridge uses a forwarding database (also known as a forwarding table or filtering database) to send frames across network segments. Initially the forwarding database is empty. As nodes transmit data through the bridge, the bridge establishes a filtering database of MAC addresses and their locations on the network. To translate between two segments, a bridge reads a frame's destination MAC address and decides to either forward or filter.
If an address entry is not found in the forwarding database, the frame is forwarded to all segments except the segment with the source address. By means of these broadcast frames, the destination segment will respond and a forwarding database entry will be created.
A bridge and a switch are very similar, the terms bridge, switch, and layer 2 switch often being used interchangeably. The only real difference is, if it has a small number of ports it might be referred to as a bridge, if it has a a larger number of ports it would be referred to as a switch.
A bridge and a router my physically appear the same, but bridges look at the MAC address to decide which network segment to send a frame to, while a router looks inside each packet to identify the source and target IP addresses and chooses the best path for the packet to travel. So routers are much more sophisticated than a bridge or a switch.
More Networking Topologies Articles:
• Beginners Guide to Fiber Optic Bit Error Ratio (BER) Measurement
• An introduction to Linux Network Routing
• Trunking, Bonding, Aggregation; What Does it Mean?
• Wireless or Wired Network?
• Bluetooth Basics
• Overview of IEEE 802.11 Wireless Lan Technology
• Understanding the Basics of All-Optical Switching
• Hubs, Switches and Routers - What's the Difference?
• Introduction to ATM (Asynchronous Transfer Mode) Networks
• The IEEE 802.3 Ethernet Standards